FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
From pull to bump

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper Engines
View previous topic :: View next topic  

Author Message
chuckla1



Joined: 11 Aug 2006
Posts: 2
Location: Deltona Florida

PostPosted: Wed Aug 16, 2006 2:12 pm    Post subject: From pull to bump Reply with quote

Hi i'm new to the site and new to buggy racing. I have a Hyper 7 with a hyper 21-8 port pull start and the pull start sux so what will I need to convert this motor to a bump start?


Thanks
Chuck
Back to top
View user's profile Send private message
Author Message
Wookiee528



Joined: 25 Oct 2005
Posts: 2569
Location: Monrovia, CA

PostPosted: Wed Aug 16, 2006 3:02 pm    Post subject: Reply with quote

sealed back plate (part number 53017) and a starter box. take off the pull-start plate, put on the 53017 plate and you are ready.

-Jim
Back to top
View user's profile Send private message
Author Message
hybridom



Joined: 08 Feb 2006
Posts: 850
Location: st. thomas, ontario, canada

PostPosted: Wed Aug 16, 2006 4:33 pm    Post subject: Reply with quote

you will gain a little by removing the pullstart/ 1 way bearing, but you dont have to.....my bashers have the pullstarts still installed just as a backup in case the starter box dies
Back to top
View user's profile Send private message MSN Messenger
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper Engines All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back