FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
Installation of Non Pull Start Cover

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Ultra LX Series
View previous topic :: View next topic  

Author Message
bebitobebo



Joined: 23 Sep 2013
Posts: 2
Location: Carolina, PR

PostPosted: Mon Sep 23, 2013 4:03 am    Post subject: Installation of Non Pull Start Cover Reply with quote

Hi,

I trying to find the instructions on converting a pull start .28 force engine to a non pull start. If there any special thing needed to be done inside the engine to install the non pull start cover.
Back to top
View user's profile Send private message
Author Message
David S.



Joined: 04 Apr 2008
Posts: 406

PostPosted: Mon Sep 23, 2013 9:40 am    Post subject: Reply with quote

Remove the complete pullstart assembly. Once removed remove the
pin & spring from the crankshaft pin. Then just install the non-pullstart backplate. Make sure you install the backplate with the flat side pointing up.

Here is a link to the exploded view:

http://www.ofna.com/pdf/52217-Force-28.pdf

Hope this helps.
Back to top
View user's profile Send private message
Author Message
bebitobebo



Joined: 23 Sep 2013
Posts: 2
Location: Carolina, PR

PostPosted: Mon Sep 23, 2013 11:49 am    Post subject: Reply with quote

Thanks for the info.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Ultra LX Series All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back