FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
camber on tire truer

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> General Discussion
View previous topic :: View next topic  

Author Message
jgwickha



Joined: 09 Sep 2015
Posts: 2

PostPosted: Wed Sep 09, 2015 9:49 am    Post subject: camber on tire truer Reply with quote

Just started to use my new tire truer.

How can I set the camber on the ofna manual tire truer?

Thank you,
Jack
Back to top
View user's profile Send private message
Author Message
David S.



Joined: 04 Apr 2008
Posts: 443

PostPosted: Mon Sep 14, 2015 8:48 am    Post subject: Reply with quote

Just loosen the 2 screws beneath the tool rest.
You will be able to move the rear part of the tool rest inboard for a camber cut (coned tire).
Unfortunately there is not a graduation scale on the machine so setting the camber cut will be trial and error.

Hope this helps
Back to top
View user's profile Send private message
Author Message
jgwickha



Joined: 09 Sep 2015
Posts: 2

PostPosted: Mon Sep 14, 2015 10:35 am    Post subject: Reply with quote

THANK YOU,
jACK
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> General Discussion All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back