FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
#ofna30963 90amp esc

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Brushless Motors & ESC info
View previous topic :: View next topic  

Author Message
Leeman1004



Joined: 16 Feb 2008
Posts: 17

PostPosted: Sun Apr 08, 2012 5:54 pm    Post subject: #ofna30963 90amp esc Reply with quote

just got a LX2e and ran it around the yard a few times. them it just stopped. it dint come with manual on esc and it was a sealed box. does anybody have anything that would help. i charged battery and pluged in and get the sound and beep then ywo led light go back and fourth. i tried holding and the turning on but nothing changes. plz help.
Back to top
View user's profile Send private message
Author Message
David S.



Joined: 04 Apr 2008
Posts: 421

PostPosted: Mon Apr 09, 2012 6:46 am    Post subject: Reply with quote

The speed control is a plug and play type. Try your radio settings. Double check the system is bound, and your throttle settings are in the neutral position. Also to test you may want to disconnect the esc and plug you steering servo into it to test that channel. You will need a seperate battery source for that test.

Hope this helps.
Back to top
View user's profile Send private message
Author Message
Leeman1004



Joined: 16 Feb 2008
Posts: 17

PostPosted: Mon Apr 09, 2012 4:57 pm    Post subject: Reply with quote

radio id binded i have another system in it now that works fine with same receiver. so its connected. wouldnt that tell me about the N postion being set right?
Back to top
View user's profile Send private message
Author Message
pegleg6942



Joined: 23 Oct 2014
Posts: 1
Location: Modesto, Ca

PostPosted: Thu Oct 23, 2014 4:57 am    Post subject: Reply with quote

I'm new to brushless systems and I just got the Ofna Ultra LX2e and was wondering about the low lipo battery setting on the esc. No where in the manual does it say anything about this. What do i need to do to see if it's already turned on and what is the low lipo battery setting set at? Thanks in advance for all the help here
Back to top
View user's profile Send private message
Author Message
David S.



Joined: 04 Apr 2008
Posts: 421

PostPosted: Thu Oct 23, 2014 8:38 am    Post subject: Reply with quote

The Low voltage cutoff is set at 3.2volt per cell.
The ESC is pre-programmed from the factory.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Brushless Motors & ESC info All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back