OFNA Nitro Talk Back Forum :: View topic



	FAQ Search Memberlist Register Profile P.M. Log in

hyper 18 sg carb issues

OFNA Nitro Talk Back Forum Forum Index -> Engine Lounge

View previous topic :: View next topic

Author

Message

redlined_b16a

Joined: 29 Jun 2008
Posts: 91

Posted: Fri Oct 22, 2010 3:23 pm Post subject: hyper 18 sg carb issues

I recived a Hyper 10sc from ebay,Looks new but heres the problems Steering wheel is broke off the tx wont attempt to start,floods out even with hsn fully closed heres what I found wrong The carb slide is very tight in the carb The low speed needle has wear marks on it like it was rubbing the brass insert. the engine has plenty compression and pinch,it lokks as though its never ran,Shiny aluminum piston the glow plug had double gaskets on it whats up with this engine,I suspect that its flooding due to the needle being messed up but the slide after the carb is cleaned is way too tight

Author

Message

redlined_b16a

Joined: 29 Jun 2008
Posts: 91

Posted: Fri Oct 22, 2010 5:49 pm Post subject:

update carb full in pieces with only the barrel,barrel is still too tight found an air leak at the hsn with the aluminum washers that are supposed to seal the fuel inlet swivel but the carb is plastic so Im affraid to overtighten to make the seal engine did however start but only idle with hsn @ .5 turn from closed....barely open and it still died every time from flooding out is there any info on this engine? manual? another aluminum carb that fits and what erks me the most is complaining about this product....im a huge diehard ofna fan

Display posts from previous:

	OFNA Nitro Talk Back Forum Forum Index -> Engine Lounge	All times are GMT - 9 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum