FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
Hyper 7 black break in

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper 7
View previous topic :: View next topic  

Author Message
dhsa7



Joined: 13 Sep 2010
Posts: 4
Location: san antonio tx

PostPosted: Mon Sep 13, 2010 4:21 pm    Post subject: Hyper 7 black break in Reply with quote

I have a hyper 7 black with the macstar 28 coming in the mail at the end of the week and I wanted to know if there were any recommendations on how to break it in. Iv'e heard the instructions don't go over it. I have had a nitro car in the past so I know how to tune but it was used so I have never broken in a new motor.

Thanks
Back to top
View user's profile Send private message
Author Message
VWVR6_T



Joined: 23 Aug 2009
Posts: 384
Location: Western, PA

PostPosted: Mon Sep 13, 2010 6:59 pm    Post subject: Reply with quote

Go to this link http://ofna.com/forum/viewtopic.php?t=3 you can used that system. Good luck
Back to top
View user's profile Send private message
Author Message
dhsa7



Joined: 13 Sep 2010
Posts: 4
Location: san antonio tx

PostPosted: Tue Sep 14, 2010 5:17 pm    Post subject: Reply with quote

Thats what I was looking for. Thanks
Back to top
View user's profile Send private message
Author Message
VWVR6_T



Joined: 23 Aug 2009
Posts: 384
Location: Western, PA

PostPosted: Tue Sep 14, 2010 9:06 pm    Post subject: Reply with quote

Back to top
View user's profile Send private message
Author Message
dhsa7



Joined: 13 Sep 2010
Posts: 4
Location: san antonio tx

PostPosted: Thu Sep 16, 2010 6:32 pm    Post subject: Reply with quote

Also do you know the default needle settings for the macstar? Or at least a starting point where I should have them?
Back to top
View user's profile Send private message
Author Message
redlined_b16a



Joined: 29 Jun 2008
Posts: 91

PostPosted: Fri Sep 17, 2010 1:55 am    Post subject: Reply with quote

My Mac wouldn't attempt to start until I closed the hsn to 3.5 turns out,the Mac is different from the .21 instructions provided
Back to top
View user's profile Send private message
Author Message
VWVR6_T



Joined: 23 Aug 2009
Posts: 384
Location: Western, PA

PostPosted: Fri Sep 17, 2010 8:43 pm    Post subject: Reply with quote

dhsa7 wrote:
Also do you know the default needle settings for the macstar? Or at least a starting point where I should have them?

Put the needles flush with the housing, both of them.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper 7 All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back