Shampue
Joined: 17 Jun 2010
Posts: 1
|
 Posted: Thu Jun 17, 2010 9:53 am Post subject: Servo assembly and wire routing. |
 |
|
Hello.
Building my first Nitro vehicle (Hyper 10sc) and am scratching my head on the servos.
With the steering servo having to be mounted where it is, and in the direction it is, the wires leading off the servo face the front of the truck. The receiver box is mounted in the rear of the truck. I either have to run the wires around the front of the servo (which get in the way of the horn) or the back of the servo which then rub the Spur gear (obviously not good)
Also, the throttle servo, again how it has to mount, the wires lead off to the rear which is good, but the servo sits so close to the receiver box that the wires get pinched when you try to route them to the receiver box opening.
I'm getting a little frustrated trying to finish this build, and as its my first ever Nitro vehicle I feel completely stupid about this issue.
Would someone who also has one of these truck be able to share a photo or something with me to help me better understand how I can correct this issue?
Thanks in advance for helping. |
|
FAQ 
Search 
Memberlist
Register
Profile 
P.M. 
Log in
