thunderbolt427
Joined: 15 Aug 2009
Posts: 119
Location: Alabama
|
 Posted: Tue Mar 16, 2010 1:16 pm Post subject: 4-port replacement for 3 port hyper.21 |
 |
|
| I purchased the new 4 -port sleeve to replace my worn 3-port. once it arrives in the mail i went to install it only to find the piston was not cut on the front to clear the crank throw and, the sleeve diameter was way to large to fit the block. now i understand that you want a tight fit but i refuse to hammer the sleeve in. can only imagine what it would be like trying to get it out. no thanks. Is this maybe a wrongly packaged replacement or has anyone else had this issue with the 4- port replacement? |
|
FAQ 
Search 
Memberlist
Register
Profile 
P.M. 
Log in
