 |
 |
|
 |
|
| Author |
Message |
Rooky
Joined: 30 Dec 2011
Posts: 5
Location: USA
|
 Posted: Sat Dec 31, 2011 12:08 am Post subject: Differential problem |
 |
|
hi everyone. i have an ofna ultra lx 2.
the differential on my rear side clicks and was little hard to turn on every 3rd turn of the input shaft. i disassembled the housing and checked all the teeth, it was all good. re installed it properly. didnt solve the problem.
anyone have the same issue? cuz its happening on my friends too. |
|
| Back to top |
|
|
|
 |
|
 |
|
|
|
|
| Author |
Message |
DJ
Joined: 22 Jun 2006
Posts: 979
|
| Posted: Tue Jan 03, 2012 8:46 am Post subject: |
|
|
| I would look the at diff case (30010) more closely you might have a bad bearing that offset the box, so the gear mesh may look good but off just a tad. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
| Author |
Message |
Rooky
Joined: 30 Dec 2011
Posts: 5
Location: USA
|
| Posted: Tue Jan 03, 2012 9:12 pm Post subject: |
|
|
| DJ wrote: |
| I would look the at diff case (30010) more closely you might have a bad bearing that offset the box, so the gear mesh may look good but off just a tad. |
well, i was told cuz the car is new, so u have to let the teeth break in a little bit. and also it does wiggle little front to rear if u reallying to to wiggle the out put shaft.. how do i shim that? put a tape around the bearings? |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
|
|
FAQ 
Search 
Memberlist
Register
Profile 
P.M. 
Log in
