 |
 |
|
 |
|
| Author |
Message |
max3290
Joined: 04 Sep 2010
Posts: 1
|
 Posted: Sat Sep 04, 2010 6:36 pm Post subject: Question about Hyper .21 8-Port Race Engine |
 |
|
I recently purchased an Ofna Hyper .21 8-Port Race Engine Rear Exhaust OFNG0152. Is it possible to add a pull start, torque start, or anything similar?
Thanks,
Max |
|
| Back to top |
|
|
|
 |
|
 |
|
|
|
|
| Author |
Message |
VWVR6_T
Joined: 23 Aug 2009
Posts: 384
Location: Western, PA
|
| Posted: Sun Sep 05, 2010 8:18 am Post subject: |
|
|
The crankshaft came with the hole to hook up the pull start I would said yes you can. But, this engines runs alot better and you can get more performance out of them without the pull start.
Note: Make sure the the piston is in the top position before you take the back plate otherwise you will damage the piston. Hope this help. GL
This is the part that you need OFN53032 from Nitrohouse. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
| Author |
Message |
testosterone
Joined: 24 Apr 2012
Posts: 5
Location: somerset, england
|
| Posted: Tue Apr 24, 2012 11:34 pm Post subject: removing back plate |
|
|
| Just a question how does removing the back plate with the piston NOT at tdc damage the piston, |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
| Author |
Message |
David S.
Joined: 04 Apr 2008
Posts: 375
|
| Posted: Wed Apr 25, 2012 6:20 am Post subject: |
|
|
| Many backplates have a piston clearence groove in them. By putting the piston at Top Dead Center the skirt is out of the groove and no damage is done to the piston skirt. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
|
|
FAQ 
Search 
Memberlist
Register
Profile 
P.M. 
Log in
