FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
Servo assembly and wire routing.

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper Short Course Nitro
View previous topic :: View next topic  

Author Message
Shampue



Joined: 17 Jun 2010
Posts: 1

PostPosted: Thu Jun 17, 2010 9:53 am    Post subject: Servo assembly and wire routing. Reply with quote

Hello.

Building my first Nitro vehicle (Hyper 10sc) and am scratching my head on the servos.

With the steering servo having to be mounted where it is, and in the direction it is, the wires leading off the servo face the front of the truck. The receiver box is mounted in the rear of the truck. I either have to run the wires around the front of the servo (which get in the way of the horn) or the back of the servo which then rub the Spur gear (obviously not good)

Also, the throttle servo, again how it has to mount, the wires lead off to the rear which is good, but the servo sits so close to the receiver box that the wires get pinched when you try to route them to the receiver box opening.

I'm getting a little frustrated trying to finish this build, and as its my first ever Nitro vehicle I feel completely stupid about this issue.

Would someone who also has one of these truck be able to share a photo or something with me to help me better understand how I can correct this issue?

Thanks in advance for helping.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper Short Course Nitro All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back