 |
 |
|
 |
|
| Author |
Message |
mikeypipes
Joined: 01 May 2010
Posts: 1
Location: san diego
|
 Posted: Sat May 01, 2010 4:22 pm Post subject: .26 max break in problems |
 |
|
Hello all,
I'm currently breaking in the picco .26 max in my tmaxx. I am using the traxxas method, and on the 5th tank where I am supposed to gradually hit full throttle, it bogs down when I get past half throttle. I have the lsn at 1mm past the throttle arm and the hsn is a full turn past flush. The car idles fine and takes off without much hesitation. I am still fairly new to the hobby, so any help would be appreciated. I am using the stock tmaxx throttle servo and linkage and it seems to have a hard time with the carb slide. Any suggestions on a good servo setup? |
|
| Back to top |
|
|
|
 |
|
 |
|
|
|
|
| Author |
Message |
VWVR6_T
Joined: 23 Aug 2009
Posts: 384
Location: Western, PA
|
| Posted: Thu May 06, 2010 9:14 pm Post subject: |
|
|
Open the HS back to flush and just start to tune with the LS and the idle, always make sure you have a stream of smoke. Make sure you have a steady idle and keep tunin the LS till you have @ .5mm open in the idle(ADJUST FUEL ACCORDING TO IDLE LOOKING TO BE STEADY). Once this LS is done then move to the HS, no need to go back to the LS, because the fuel go through the HS side then goes to the LS. If you adjust the HS w/o get the LS tune you are getting the LS lean already. Get the engine runnin to your liking and then take the temp, remember always keep a stream of smoke. Have fun!!!  |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
|
|
FAQ 
Search 
Memberlist
Register
Profile 
P.M. 
Log in
