FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
Front center universal

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper 9 Pro
View previous topic :: View next topic  

Author Message
JoeCathey



Joined: 09 Dec 2009
Posts: 28

PostPosted: Tue Feb 16, 2010 12:43 pm    Post subject: Front center universal Reply with quote

I just got the front center universal from Nitrohouse. I was wondering if anyone else experienced the same fitting problem I had. When I tried to put the driveshaft on the diff pinion, it wouldn't snug up to the bearing so the diff pinion would have no play. Not a big deal, I just dremeled the diff pinion shaft a couple of millimeters shorter and it is good.
Back to top
View user's profile Send private message
Author Message
HyperGRP



Joined: 01 Dec 2008
Posts: 137

PostPosted: Tue Feb 16, 2010 12:59 pm    Post subject: Reply with quote

An even easier fix is to shim it with two 0.3mm shims! That is all that is needed to remove the play.
Back to top
View user's profile Send private message
Author Message
JoeCathey



Joined: 09 Dec 2009
Posts: 28

PostPosted: Tue Feb 16, 2010 4:08 pm    Post subject: Reply with quote

Yes, I did try shims but I didn't have enough. It was like 1.5 to 2 mm of play.
Back to top
View user's profile Send private message
Author Message
kane



Joined: 06 Dec 2009
Posts: 42

PostPosted: Tue Feb 16, 2010 11:53 pm    Post subject: Reply with quote

i think i NEED 0.1/0.2 mm of play in pinion, ALWAYS..
Back to top
View user's profile Send private message
Author Message
HyperGRP



Joined: 01 Dec 2008
Posts: 137

PostPosted: Wed Feb 17, 2010 5:22 am    Post subject: Reply with quote

Hmm...I got my uni from Special-RC, but I can't imagine that the two parts are different since they come from the same factory. That's a pretty big difference in gap. More Q.C. is needed!
Back to top
View user's profile Send private message
Author Message
BrianB



Joined: 14 Jan 2009
Posts: 36

PostPosted: Thu Feb 18, 2010 12:21 pm    Post subject: Reply with quote

yea I add a few shims & left a tic of play. I really like that I can pull the center diff now without removing the motor
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> Hyper 9 Pro All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back