FAQFAQ SearchSearch MemberlistMemberlist  RegisterRegister  ProfileProfile Log in to check your private messagesP.M. Log inLog in
A brand new CD3 on the way....

 
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> CD3
View previous topic :: View next topic  

Author Message
swerv512



Joined: 28 Jun 2006
Posts: 98
Location: San Francisco

PostPosted: Thu Aug 03, 2006 3:25 pm    Post subject: A brand new CD3 on the way.... Reply with quote

i just ordered a cd3 pro and i cant wait to see what it can do. i had a pretty tricked out ld3 about 2 years ago. i wanted another ofna car because i remeber how reliable my ld3 was. i hope the same goes for the cd3.
Back to top
View user's profile Send private message
Author Message
Nightmare



Joined: 06 Jan 2006
Posts: 29

PostPosted: Fri Aug 04, 2006 10:32 pm    Post subject: Reply with quote

you should like it better :) I know I do. Better clutch, 0.8 gears are much better then the 1.0 module, better exhaust system & selection, the list goes on :)
Back to top
View user's profile Send private message
Author Message
bermudian



Joined: 11 Jul 2006
Posts: 6

PostPosted: Sun Aug 06, 2006 3:06 pm    Post subject: Reply with quote

See if you guys can help me out on this......My CD3 pro is having a had time keeping the screws on my pipe coming off the block. I've tried locktite and everything but the thing keeps coming undone.....got any suggestions?
Back to top
View user's profile Send private message Send e-mail MSN Messenger
Author Message
swerv512



Joined: 28 Jun 2006
Posts: 98
Location: San Francisco

PostPosted: Tue Aug 08, 2006 12:01 pm    Post subject: Reply with quote

are you using a high temp loctite?
Back to top
View user's profile Send private message
Author Message
Nightmare



Joined: 06 Jan 2006
Posts: 29

PostPosted: Sat Aug 12, 2006 10:13 pm    Post subject: Reply with quote

I've only had one side exhaust engine and I used screws long enough to get a low profile nut on the other side :)

For Rear engines the exhaust the springs are pretty much trouble free :)
Back to top
View user's profile Send private message
Author Message
CDS70



Joined: 17 May 2006
Posts: 3
Location: Sydney Australia

PostPosted: Mon Aug 14, 2006 8:52 pm    Post subject: Reply with quote

Buy a header that allows you to put nuts on the other side. You will find that eventually the screws that srew into the header will pull through as it's only alloy.

As you will see there is not much room with the rear screw between the header flange and the header. If you can get low profile nuts they may work, but ultimately a different header is the way to go. Good Luck!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OFNA Nitro Talk Back Forum Forum Index -> CD3 All times are GMT - 9 Hours
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
ofna nitro talk back